BHXHW - ID 775-7329, 81-65-2, USDA YELLOW TMP
- MSDS: BHXHW
- Manufacturer: SOUTHERN COATINGS
- Product Name: ID 775-7329, 81-65-2, USDA YELLOW TMP
- National Stock Number: 8010-01-274-2567
Product Identification
Product ID:ID 775-7329, 81-65-2, USDA YELLOW TMP
MSDS Date:05/03/1990
FSC:8010
NIIN:01-274-2567
MSDS Number: BHXHW
Responsible Party
US
Emergency Phone: 803-775-6351
Info Phone: 803-775-6351
Cage: 6M840
Contractor
Telephone: 803-775-6351
Cage: 6M840
Ingredients
TITANIUM DIOXIDE
CAS: 13463-67-7
RTECS: XR2275000
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST; 9293
MINERAL SPIRITS
CAS: 64742-88-7
OSHA PEL 100 PPM/525 MG/CU.M.
ACGIH TLV: 100 PPM/525 MG/CU.M.
VOC. 4.78 LB/GAL LESS WATER & NEGLIGIBLY PHOTOCHEMICALLY
RTECS: 9999999VO
VOC. 18.04 LB/GAL SOLIDS 2165 G/L SOLIDS CALCULATED
RTECS: 9999999VO
4.19 LB/GAL LESS WATER & NEGLIGIBLY PHOTOCHEMICALLY
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:REPORTS HAVE ASSOCIATED PROLONGED &
REPEATED OCCUPATIONAL OVEREXPOSURE TO SOLVENT WITH PERMANENT BRAIN
& NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING & INHALING THE CONTENTS MAY BE HARMFUL OR FATAL.
ACUTE CENTRALNERVOUS SYSTEM DEPRESSION, CHARACTERIZED:HEADACHE,
DIZZINESS, NAUSEA & CONFUSION
Explanation of Carcinogenicity:AT TLV TIO2 MFR CONCLUDES THERE IS NO
SIGNIF HAZARD FOR MAN.RAT REVEAL SIGNIF INCREASE IN LUNG TUMORS
W/HIGH CONCENT***
Effects of Overexposure:SWALLOW: CAN CAUSE GASTROINTESTINAL IRRITATION,
NAUSEA, VOMITING. ASPIRATION OF MATERIAL INTO LUNGS MAY CAUSE
CHEMICAL PNEUMONITIS WHICH CAN BE FATAL. INHALATION: MAY CAUSE NOSE
OR THROAT IRRITATION, HEADACHES, DIZZINESS, NAUSEA & CONFUSION.
EYES: IRRITATION. SKIN: MAY CAUSE DEFATTING & IRRITATION OF THE
SKIN.
Medical Cond Aggravated by Exposure:N/K. *** SEE FILE FOR MORE
INFORMATION.
First Aid
First Aid:SWALLOW: DO NOT INDUCE VOMIT. CALL POISON CONTROL
CENTER/EMERG ROOM/PHYSICIAN IMMED. INHALED: REMOVE TO FRESH AIR
IMMED. IF BREATH STOPPED, GIVE CPR. KEEP WARM & QUIET. GET MED ATTN
IMMED. EYES: FLUSH WITH LARGE AMTS OF WATER, LIFTING LIDSFOR AT
LEAST 15 MINS. GET MED ATTN. SKIN: REMOVE CONTAMINATED CLOTHES.
WASH AFFECTED AREA WITH SOAP AND WATER. OBTAIN MEDICAL ATTENTION IF
IRRITATION PERSISTS.
Fire Fighting
Flash Point:>102 F/> 39 C
Extinguishing Media:USE NFPA CLASS B FIRE EXTINGUISHERS FOR FLAMMABLE
LIQUID FIRES. POLYMER FOAM IS PREFERRED FOR LARGE FIRES.
Fire Fighting Procedures:WEAR SCBA.WATER MAY BE INEFFECT, USE TO COOL
EXPOSED CONTAINER,PREVENT PRESSURE BUILD-UP/AUTO-IGNITE/EXPLOSION
FROM EXTREME HEAT.IF WATER USED-FOG NOZZLE PREFER
Unusual Fire/Explosion Hazard:OVEREXPOSURE TO DECOMPOSITION PRODUCT MAY
CAUSE DELAYED HEALTH HAZARD SYMPTOMS, OBTAIN MEDICAL ATTN. KEEP
CONTAINERS TIGHTLY CLOSED. ISOLATE FROM HEAT, *
Accidental Release
Spill Release Procedures:KEEP SPECTATORS AWAY. ELIM ALL IGNITION
SOURCES(FLAMES,HOT SURFACES,SOURCES OF ELECTRIC, STATIC OR FRICTION
SPARKS)DIKE & CONTAIN SPILL W/INERT MATERIAL(E.G. SAND,EARTH).
TRANS LIQ TO COVERED METAL CO NTAINER FOR
RECOVERY/DISPOSAL/REMOVAL. PREVENT **
Neutralizing Agent:N/K. ** CONTAMINATION OF WATERS.
Handling
Handling and Storage Precautions:DO NOT STORE ABOVE 95 DEGREES F. STORE
LARGE QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER EACH
USE. EMPTY CONTAINERS MUST NOT BE WASHED AND RE-USED FOR ANY
PURPOSE.CONTAINERS SHOULD BE GROUNDED & BONDED TO THE RECEIVING
CONTAINER.
Exposure Controls
Respiratory Protection:MAY BE REQUIRED FOR RESTRICTED VENT: USE CHEM
CARTRIDGE. FOR SPRAYING: USE MECH PREFILTER. CONFINED AREAS: USE
NIOSH/MSHA AIR SUPPLIED RESPIRATOR. IF TLV'S ARE EXCEEDED USE
PROPERLY FITTED RESPIRATOR W/APPROPRIATE PROTECT FACTOR. SEE FILE.
Ventilation:GENERAL DILUTION & LOCAL EXHAUST VENT IN SUFFICIENT
VOL/PATTERN TO MAINTAIN CONCENTRATIONS OF HAZARD BELOW LOWEST
LIMITS
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:WEAR SAFETY SPECTACLES
Other Protective Equipment:NOT LIKELY TO BE NEEDED.
Work Hygienic Practices:AVOID BREATHING VAPORS OR MISTS.
Supplemental Safety and Health
NOTE: ANY TREATMENT THAT MIGHT BE REQUIRED FOR OVEREXPOSURE SHOULD BE
DIRECTED AT THE CONTROL OF SYMPTOMS & THE CLINICAL CONDITIONS.
PRODUCT, IF DISCARDED DIRECTLY, WOULD BE CLASSIFIED HAZARDOUS WASTE
BASED ON ITS IGNITABILITY CHARACTERISTIC, I.E. HAS A FLASH POINT
OF 140 F. OR LESS. PROPER RCRA CLASSIFICATION D001.
Chemical Properties
Boiling Pt:B.P. Text:280 TO 390F
Vapor Density:> THAN AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:73
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESS HEAT & SOURCES OF IGNITE. *
ELECTRIC EQUIP, SPARKS & FLAME. CLOSED CONTAINER MAY EXPLODE FROM
EXTREME HEAT
Hazardous Decomposition Products:BURNING, INCLUDING WHEN HEATED BY
WELDING OR CUTTING, WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON
DIOXIDE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT, SPARKS AND
FLAME.
Disposal
Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL LAWS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.